-
This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.
WTS Sold
- Thread starter Intel0116
- Start date
- Status
FYI, Springfield never used the BoMar rear sight, they used LPA's which is a slightly different cut. And that sight is not a BoMar or a Dawson. It looks like a Harrison but I just wanted to make sure. Why would you remove an adjustable sight and replace it with a rather large fixed sight?
The hammer is a stock Springfield hammer so am I correct in assuming all of the trigger parts except the trigger are stock?
It that a S&A magwell? Is it blended into the frame?
The hammer is a stock Springfield hammer so am I correct in assuming all of the trigger parts except the trigger are stock?
It that a S&A magwell? Is it blended into the frame?
Last edited:
My mistake, there Harrison sights.
http://www.harrisoncustom.com
HD-006-U Extreme Service Rear Sight
103-DP-020-024 Front sight
And according to the Harrison description,
“CAD designed and CNC 3-D machined specifically to fit the Springfield TRP Operator as well the standard BoMar cut.”
It’s my understanding that the TRP is the only LPA sight.
and I removed the adjustable rear sight because it was extremely uncomfortable to carry, cut into my side and tore several shirts,( this was my carry gun for a while). Also I’m not shooting a .45acp 50+ yards so elevation is not a concern of mine, and I never had a problem with moving the front sight for windage, and never needed to adjust for either.. YMMV.
I went with a beefy rear sight for one handed racking.
Yes it’s a S&A magwell/msh.
(This was in my original description)
And no the S&A magwell is not blended.
Yes all trigger parts are stock other than the trigger itself. That’s why nothing else is listed.
http://www.harrisoncustom.com
HD-006-U Extreme Service Rear Sight
103-DP-020-024 Front sight
And according to the Harrison description,
“CAD designed and CNC 3-D machined specifically to fit the Springfield TRP Operator as well the standard BoMar cut.”
It’s my understanding that the TRP is the only LPA sight.
and I removed the adjustable rear sight because it was extremely uncomfortable to carry, cut into my side and tore several shirts,( this was my carry gun for a while). Also I’m not shooting a .45acp 50+ yards so elevation is not a concern of mine, and I never had a problem with moving the front sight for windage, and never needed to adjust for either.. YMMV.
I went with a beefy rear sight for one handed racking.
Yes it’s a S&A magwell/msh.
(This was in my original description)
And no the S&A magwell is not blended.
Yes all trigger parts are stock other than the trigger itself. That’s why nothing else is listed.
Last edited:
MAC702
I don't believe in the no-win scenario
Forum Supporter
2020 Supporter
2021 Supporter
2022 Supporter
2023 Supporter
2024 Supporter
Trading Post Subscriber
I only use my Springfield RO for competition and even with the OWB holster, the sight was sharp if it touched you, including slide manipulation. I got pretty aggressive with a file and made mine almost a semicircle. Yours looks much nicer. Got mine from WWG, too, and had them take it immediately into the back and do the trigger.
- Status