Will trade for/toward for a Canik Rival
Glock 17 gen 5 MOS
$750
set up for USPSA competition with: Timney trigger, steel guide rod with captured spring, tungsten weights and tungsten putty in grip space, grip plug, grip tape, Ghost extended magazine release, right slide release tab cut off
3 magazines, 2 with TTI extensions and springs
less than 1200 rounds fired
hard case, backstraps, MOS plates included
Glock 43
$375
Front tritium sight. Never holstered. Low round count. Multiple winner of GSSF Pocket Glock division. Recent check by Glock armorer.
custom Open division pistol for USPSA and Steel Challenge
$850
C-More not included
Built by Bruce Gray from Springfield Armory P9 long slide (Tanfoglio small frame). Welded up beavertail and magazine well. Custom and aftermarket parts including WCPI barrel and trigger. Mount for C-More Slide Ride red dot sight. Chambered for 9x21, easily loaded with 9x19 dies and data. Also fires 9x19. Includes 6 extended magazines, 9x21 brass, and case gauge.
Springfield Armory P9
$350
Approximately 1993 vintage. Lots of rounds through it. Custom front sight, black serrated. Honest wear on the high polish blue (highest wear is pictured). Right side of rear sight is dinged up from brass hammer. Fully checkered grips. Includes 3 magazines with bumper base pads and original grips. Conversion kit for 22LR available.
Marocchi Conquista USA Sporting
$1100
Adjustable comb, adjustable trigger, 30" ported barrels, tight. Low round count. Includes a selection of extended choke tubes (Browning Invector Plus compatible). Includes hard case.
Marlin model 60
$120
Approximately 1999 vintage. Lots of rounds through it, as if it matters. Stupid accurate, even with the buckhorn sights. Runs stuff like Golden Bullets and AutoMatch. A ding on the receiver where I mounted an aftermarket sight.
AR-15
$775
16" 1/7 mid-gas barrel under Midwest free float top rail handguard. A2 birdcage flash hider. JP fire control with red hammer spring. Noveske 45 degree safety. Ergo grip. Magpul collapsible stock. Non-assist upper as Stoner intended. Anderson lower. Lovingly assembled in my garage. Test fired with one magazine only.
AR-15 Lower Receivers
Anderson lower, mag catch/release only, small finish ding on right side. $50
SAA lower, finished (except buffer/stock) with standard parts, bobbed hammer, $125
Please don't send me glowing personal messages or texts.
Glock 17 gen 5 MOS
$750
set up for USPSA competition with: Timney trigger, steel guide rod with captured spring, tungsten weights and tungsten putty in grip space, grip plug, grip tape, Ghost extended magazine release, right slide release tab cut off
3 magazines, 2 with TTI extensions and springs
less than 1200 rounds fired
hard case, backstraps, MOS plates included
Glock 43
$375
Front tritium sight. Never holstered. Low round count. Multiple winner of GSSF Pocket Glock division. Recent check by Glock armorer.
custom Open division pistol for USPSA and Steel Challenge
$850
C-More not included
Built by Bruce Gray from Springfield Armory P9 long slide (Tanfoglio small frame). Welded up beavertail and magazine well. Custom and aftermarket parts including WCPI barrel and trigger. Mount for C-More Slide Ride red dot sight. Chambered for 9x21, easily loaded with 9x19 dies and data. Also fires 9x19. Includes 6 extended magazines, 9x21 brass, and case gauge.
Springfield Armory P9
$350
Approximately 1993 vintage. Lots of rounds through it. Custom front sight, black serrated. Honest wear on the high polish blue (highest wear is pictured). Right side of rear sight is dinged up from brass hammer. Fully checkered grips. Includes 3 magazines with bumper base pads and original grips. Conversion kit for 22LR available.
Marocchi Conquista USA Sporting
$1100
Adjustable comb, adjustable trigger, 30" ported barrels, tight. Low round count. Includes a selection of extended choke tubes (Browning Invector Plus compatible). Includes hard case.
Marlin model 60
$120
Approximately 1999 vintage. Lots of rounds through it, as if it matters. Stupid accurate, even with the buckhorn sights. Runs stuff like Golden Bullets and AutoMatch. A ding on the receiver where I mounted an aftermarket sight.
AR-15
$775
16" 1/7 mid-gas barrel under Midwest free float top rail handguard. A2 birdcage flash hider. JP fire control with red hammer spring. Noveske 45 degree safety. Ergo grip. Magpul collapsible stock. Non-assist upper as Stoner intended. Anderson lower. Lovingly assembled in my garage. Test fired with one magazine only.
AR-15 Lower Receivers
Anderson lower, mag catch/release only, small finish ding on right side. $50
SAA lower, finished (except buffer/stock) with standard parts, bobbed hammer, $125
Please don't send me glowing personal messages or texts.
Last edited:
