MAC702
I don't believe in the no-win scenario
Forum Supporter
2020 Supporter
2021 Supporter
2022 Supporter
2023 Supporter
2024 Supporter
Trading Post Subscriber
I have a ton of cast bullets that need sizing/lube. I have Lyman and RCBS lube/sizing presses that were loaned to me. If I have to buy the dies, I will, but after this huge table full of bullets, I can't see ever needing to do this again, so if the dies are already out there and available to be borrowed, that's Plan A. Buying some used dies is Plan B. Amazon is Plan C.
I believe I'm in need of the following sizes: .356", .358", 430", and .452". I've never done this before, so do I need separate top punches for all of these, or is it universal? I'll be doing some reading up this process when I get a chance.
I believe I'm in need of the following sizes: .356", .358", 430", and .452". I've never done this before, so do I need separate top punches for all of these, or is it universal? I'll be doing some reading up this process when I get a chance.
