18+ Content Warning

This forum may contain content not suitable for minors.
By clicking "Enter", you confirm that you are
18 years of age or older
and agree to proceed at your own discretion.
Be sure to Read the Terms and Rules before participating.

  • A limited run of Nevada Shooters hats are now available!
    CLICK HERE for details!

WTS/WTT 12"x36" Clausing Model 5914

Status
Not open for further replies.
Location (City)
Pahrump
jimf5

jimf5

Member (9mm)
Forum Supporter
2019 Supporter
Rating - 100%
12   0   0
For sale:
Clausing Engine Lathe around 1960's built. It is in good shape as I ran it this morning.
It is set up for a collet system and has a full set of collets. It also has a an Aloris quick
change tool post and a few tool holders and limited inserts. I am asking $4000.00 OBO and
No I will not deliver. Any questions please PM me. 20180711_105844.jpg
I will post more pics as soon as i find them. This is just of the collets.
Jimf5
in Pahrump
more pics. just to clarify the red tinge on the ways is the grease not rust. ways are perfect
newlathe1.jpg
newlathe2.jpg
 
Last edited:
Very nice!

Tell us the range of collet sizes, list the different styles of toolpost tool holders - I see indexable carbide cutters there, list the range of spindle speeds and threading capacity

Are there any face plates or other chucks there?
Are there spindle nose adapters?
Do you have the dead center for the spindle?

What voltage is it running?

This looks like a nice setup for someone
List the features
 
Status
Not open for further replies.
Back
Top