18+ Content Warning

This forum may contain content not suitable for minors.
By clicking "Enter", you confirm that you are
18 years of age or older
and agree to proceed at your own discretion.
Be sure to Read the Terms and Rules before participating.

  • A limited run of Nevada Shooters hats are now available!
    CLICK HERE for details!

WTS S&W 686 6" Stainless SOLD

Status
Not open for further replies.

superlight93

Member (9mm)
Forum Supporter
2024 Supporter
2025 Supporter
Trading Post Subscriber
Rating - 100%
12   0   0
In my opinion the best 357 Smith made. This fine example is the first year no dash model. Appears hardly fired with a very faint turn line. Includes everything when sold new. Located in Summerlin. $80020190829_110823.jpg20190829_110823.jpg20190829_110823.jpg20190829_110833.jpg20190829_111049.jpg20190829_200446.jpg20190829_200648.jpg
 
I have one just like it! No box or papers though. Is yours M marked or was it not sent in for the recall?
 
The recall involved changing the hammer nose and the bolster bushing ( hammer nose bushing ) in the frame. With certain ammo the hammer nose would stick in the bushing. After the repair the revolvers were test fired and the M was stamped in the yoke.
This was not a required recall. In other words, S&W did not try to get all the guns returned for repair. The problem did not show up on all guns produced and S&W only handled the repairs on a case by case basis. Many folks have fired thousands of rounds through these guns with no problems.
__________________
Master Blaster, Apr 26, 2018
#13
 
Uh, it WAS a small batch of fp bushings that were out of spec. It was NOT a general problem of the whole line. If you aren't familiar with this recall, you can call S&W and ask about it. You WILL need to find someone who has specific knowledge of it, like Kate F., to get the whole story. Since it was impossible to know which guns had the out-of-spec part, a general recall was issued for the whole engineering series. This is how recalls work when the individually affected units, no matter how few, can't be identified.

If the bushing is out of spec, it will become apparent when there is an indexing issue with magnum loads. I believe they said it was less than 1% of the recalled guns that were actually affected.
Oro, Jun 23, 2009
 
A member contacted me and said S&W will check pistol for free postage paid both ways.
 
My wife should be hoping that one of you guys grab this soon. I don’t NEED it, but I really WANT it.
 
That’s a great revolver, I had one just like it, stolen. I replaced it a couple of years ago, the new ones are not nearly as nice. My new one is a 7 shooter, but lacks the quality of the older ones like yours. Good luck with the sale!
 
Status
Not open for further replies.
Back
Top