Please read this disclaimer:
I had a high-end, very light trigger installed in this build before. During a very high rate of fire, the trigger would release before the bolt was fully in battery, causing the casing to explode, which shot the magazine out. This occurred 3 times with this trigger between 3 magazines of ammo. Since I have installed a milspec trigger and I’ve tested it with 5 magazines at a high rate of fire and it seemed to fix the problem with 0 failures. Due to this failure with the high-end trigger, I’ve added this disclaimer to inform any potential buyer that using a higher end trigger could cause this failure and should stick with a standard trigger. Feel free to reach out with any questions!
For sale is my New Frontier Armory (NFA) PCC Glock 9mm 16” build. Bought it a while back when they still had a store front. Fired very little (totaling under 400 rounds) and, other than the disclaimer above, no issues with the rifle. NFA upper and lower, 16” barrel threaded to 1/2x36 with a tri-lug suppressor muzzle piece, full length top picatinny rail with M-Lok 3, 6, and 9 forend. Palmetto State Armory standard trigger, foldable buttstock, Brave Company Manufacturer charging handle. LRBHO with Glock magazines as its feed source.
Asking $700, open to trades. Worst I can say is no.
As always, feel free to reach out with any questions! Thank you.
I had a high-end, very light trigger installed in this build before. During a very high rate of fire, the trigger would release before the bolt was fully in battery, causing the casing to explode, which shot the magazine out. This occurred 3 times with this trigger between 3 magazines of ammo. Since I have installed a milspec trigger and I’ve tested it with 5 magazines at a high rate of fire and it seemed to fix the problem with 0 failures. Due to this failure with the high-end trigger, I’ve added this disclaimer to inform any potential buyer that using a higher end trigger could cause this failure and should stick with a standard trigger. Feel free to reach out with any questions!
For sale is my New Frontier Armory (NFA) PCC Glock 9mm 16” build. Bought it a while back when they still had a store front. Fired very little (totaling under 400 rounds) and, other than the disclaimer above, no issues with the rifle. NFA upper and lower, 16” barrel threaded to 1/2x36 with a tri-lug suppressor muzzle piece, full length top picatinny rail with M-Lok 3, 6, and 9 forend. Palmetto State Armory standard trigger, foldable buttstock, Brave Company Manufacturer charging handle. LRBHO with Glock magazines as its feed source.
Asking $700, open to trades. Worst I can say is no.
As always, feel free to reach out with any questions! Thank you.
